Salta al contenuto principale

Modifiche a questo Step

Modifica in base a Nick-

Modifica approvata da Nick

Prima di
Dopo il
Invariato

Righe Passo

[* black] Remove the print head from the printer. Check the documentation that came with the printer to determine how to remove the print head.
-[* black] Turn off the printer. Disconnect the printer from electric power. Do this while the printer is on in this state to avoid doing the first use ink purge, and do not close the printer, but leave it exactly as found.
+[* black] Turn off the printer. Disconnect the printer from electric power. Do this while the printer is on in this state to avoid the first use ink purge Do not close the printer, but leave it exactly as found.
[* black] Place the print head in the bowl and allow it to soak. Allow time for the water to dissolve ink deposits on the print head.
-[* icon_reminder] Periodically move the print head in the bowl to help dissolve ink deposits. Change water in the bowl as often as needed until it is reasonably clear, indicating the print head is free of ink deposits. It doesn't have to be perfect, but has to be nearly clean water.
+[* icon_reminder] Periodically move the print head in the bowl to help dissolve ink deposits. Change water in the bowl as often as needed until it is reasonably clear, indicating the print head is free of ink deposits.
[* icon_caution] Dry the print head thoroughly before replacing it in the printer or you may damage the printer and/or the print head.
-[* icon_reminder] Closing the printer without a printhead causes it to forget all the alignment and calibration settings, along with thinking it's new print head install. The reason behind my bypass is to allow you to pull the print head and preserve the "used" status of the printer and alignment. Heavy ink waste should be expected if not followed correctly.
+[* icon_reminder] Closing the printer without a printhead causes it to forget all the alignment and calibration settings, along with thinking it's new print head install. The reason behind this bypass is to allow you to pull the print head and preserve the "used" status of the printer.