Salta al contenuto principale

Modifiche al passo #7

Modifica in base a Nick-

Modifica approvata da Nick

Prima di
Dopo il
Invariato

Righe Passo

[title] Clean the printhead
[* icon_caution] Alcohol should only be used as a last resort since it can damage the printhead. If alcohol is used, purge the printhead with clean water ***THREE TIMES***.
-[* icon_note] As the ink clears up, the ink should get progressively lighter. This will take multiple cycles on heavily clogged printers. ***Tip: If your printer has a stubborn clog, an ultrasonic cleaner or small paintbrush can help with these clogs.***
+[* icon_reminder] The water will get lighter as the ink is cleared from the printhead. As such, you will need to do this multiple times. ***Tip:*** Stubborn clogs that do not clear easily may come out if an ultrasonic cleaner or paintbrush is used.
[* icon_note] Put the printhead in front of a fan to speed up the drying time.
-[* icon_reminder] ***Recommended circulation times:*** ***With alcohol:*** 5-10 minutes. ***Without alcohol:*** 15 minutes.
-[* black] Pour hot water into a bowl and let the printhead sit. As the water gets dirty, change it out. Once the water is reasonably clear, the printhead is clean.
-[* black] Remove the printhead and dry the nozzles and electrical contacts by hand. This will help mitigate the ***Printhead problem*** error.
-[* black] While the printhead is likely ready to use, allow the printhead to dry before installation. Let the printhead dry outside the printer for ~2-3 hours.
+[* icon_note] ***Recommended circulation times:*** ***With alcohol:*** 5-10 minutes. ***Without alcohol:*** 15 minutes.
+[* red] Pour hot water into a bowl and let the printhead sit. Change the water as it gets dark and unusable. Do this until the water is reasonably clear.
+[* orange] To mitigate ***Printhead Problem*** errors, dry the contacts and nozzles by hand.
+[* yellow] Before reinstalling the printhead, let it dry for ~2-3 hours outside of the printer.