Salta al contenuto principale

Aggiusta la tua roba

Diritto alla Riparazione

Componenti & Strumenti

Modifiche al passo #3

Modifica in base a bushing-

In attesa di approvazione

Eliminato
Aggiunto
Invariato

Righe Passo

[* black] With the ethernet connectorsrear side of the device (with Ethernet connectors) facing youyou, carefully open the unit likepull up on the picture. I can best describeleft side of the opening technique as you would open a book frommetal plate.
[* icon_caution] The fan is attached to
the rear covermetal plate, and connected to the motherboard next to the power connector. To prevent damage, do not lift the plate straight up or use force.
[* black] UnplugIf necessary, disconnect the fan,fan from the motherboard using a spudger can beor tweezers to pry the cable out of good use herethe connector.
[* icon_note] Unless you are replacing or working on the fanfan, you don'tmay not need to unplug it.
[* icon_caution] The fan is connected
disconnect it; if you leave it connected, take care to support the motherboard nextmetal plate to prevent it from pulling on the power connector. Don't lift the plate straight up or use forcewires while you are working.
[* black] With the ethernet connectorsrear side of the device (with Ethernet connectors) facing youyou, carefully open the unit likepull up on the picture. I can best describeleft side of the opening technique as you would open a book frommetal plate.
[* icon_caution] The fan is attached to
the rear covermetal plate, and connected to the motherboard next to the power connector. To prevent damage, do not lift the plate straight up or use force.
[* black] UnplugIf necessary, disconnect the fan,fan from the motherboard using a spudger can beor tweezers to pry the cable out of good use herethe connector.
[* icon_note] Unless you are replacing or working on the fanfan, you don'tmay not need to unplug it.
[* icon_caution] The fan is connected
disconnect it; if you leave it connected, take care to support the motherboard nextmetal plate to prevent it from pulling on the power connector. Don't lift the plate straight up or use forcewires while you are working.