Salta al contenuto principale

Aggiusta la tua roba

Diritto alla Riparazione

Componenti & Strumenti

Modifiche al passo #3

Modifica in base a Richdave-

Modifica approvata da Richdave

Eliminato
Aggiunto
Invariato

Righe Passo

[* black] With the rear side of the device (the side with Ethernet connectors) facing you, carefully pulllift up on the left side of the metal plate.
[* black] With the rear side of the device (the side with Ethernet connectors) facing you, carefully pulllift up on the left side of the metal plate.
[* icon_caution] The fan is attached to the metal plate, and connected to the logic board next to the power connector. To prevent damage, do not lift the plate straight up or use force.
[* blackred] Disconnect the fan from the logic board using aboard. A spudger or tweezers may make it easier to pry the cable out of the connectordo this.
[* blackred] Disconnect the fan from the logic board using aboard. A spudger or tweezers may make it easier to pry the cable out of the connectordo this.

Immagine 2

Vecchia Versione

Nuova Versione