Salta al contenuto principale

Aggiusta la tua roba

Diritto alla Riparazione

Componenti & Strumenti

Modifiche al passo #1

Modifica in base a Jeff G-

Modifica approvata da David Hodson

Eliminato
Aggiunto
Invariato

Righe Passo

[* black] To open the Time CapsuleCapsule, you need to expose the screws holdingthat hold the case together. The screws are coveredconcealed by the rubber base on the bottom of the unit
[* black] To open the Time CapsuleCapsule, you need to expose the screws holdingthat hold the case together. The screws are coveredconcealed by the rubber base on the bottom of the unit
[* black] Place the unit upside down on a clean flat work surface. You may want to place a piece of cloth or similar soft material underneath to protect the top surface while you work.
[* black] Use a heat gun or hair dryer to heat the rubber base and soften the adhesive holding it on.
[* icon_caution] Start in a corner and lift the rubber base being careful not to tear it
[* icon_caution] Progress slowly and avoid tearing the adhesive while ensuring you don't over heat the unit.
[* icon_note] If you tear some of the adhesiveadhesive, don't worry too much about it. The existing adhesive is more than enough to allow the rubber base should re adhere OKto stick back on to the unit during reassembly.
[* icon_note] ApplyingDuring reassembly, you can again apply heat to the rubber base when you reassembleto allow the unit may helpadhesive to stick down againflow slightly and form a better bond to the plastic case.
[* icon_note] If you tear some of the adhesiveadhesive, don't worry too much about it. The existing adhesive is more than enough to allow the rubber base should re adhere OKto stick back on to the unit during reassembly.
[* icon_note] ApplyingDuring reassembly, you can again apply heat to the rubber base when you reassembleto allow the unit may helpadhesive to stick down againflow slightly and form a better bond to the plastic case.