Skip to main content

Modifiche al passo #2

Modifica in base a Whitney Lunny-

Modifica approvata da Whitney Lunny

Eliminato
Aggiunto
Invariato

Righe Passo

[* blue] Turnblack] Position the computer over and removekeyboard side up.
[* red] Remove
the two M2.5 x 5-mm screws from the top of the palm rest.
[* greenorange] Disconnect the mouse pad cable from the main board.
[* yellow] Starting at the back center of the palm rest, separateSeparate the palm rest from the base by lifting theits inside edge ofedge. Start at the palm restback center.
[* icon_caution] Be careful when separatingto avoid damaging the palm rest while separating it from the base, to avoid damage to the palm restbase.
[* blue] Turnblack] Position the computer over and removekeyboard side up.
[* red] Remove
the two M2.5 x 5-mm screws from the top of the palm rest.
[* greenorange] Disconnect the mouse pad cable from the main board.
[* yellow] Starting at the back center of the palm rest, separateSeparate the palm rest from the base by lifting theits inside edge ofedge. Start at the palm restback center.
[* icon_caution] Be careful when separatingto avoid damaging the palm rest while separating it from the base, to avoid damage to the palm restbase.

Immagine 1

Vecchia Versione

Nuova Versione