Modifiche al passo #3
Modifica di Daniel Slusser —
Modifica approvata da Daniel Slusser
- Prima di
- Dopo il
- Invariato
Righe Passo
| + | [* black] Torque the bearing preload adjustment bolt on your stem cap just enough so that the knocking goes away. |
|---|---|
| + | [* black] Torque required is usually in the 2-3nm range. |
| + | [* black] If the steering feels rough or sluggish after tightening down the headset bearing preload bolt when turning your handlebars from side to side, you’ve over-tightened the headset. |
| + | [* black] Back it off an eighth or a quarter of a turn and check it again by turning the handlebars from side to side and pulling the front brake and rocking the handlebars front to back to feel for any knocking. |
Immagine 1
Nessuna immagine precedente.
Aggiunto
Immagine 2
Nessuna immagine precedente.
Aggiunto