Salta al contenuto principale

Aggiusta la tua roba

Diritto alla Riparazione

Store

Modifiche al passo #4

Modifica in base a Andrew Shotwell-

Modifica approvata da Marty Rippens

Prima di
Dopo il
Invariato

Righe Passo

[* black] To check the power supply of the clock, locate the electrical connector and find the pin on it which supplies the power (12v) to the clock.
[* icon_note] For testing, useblack] Take a 12vsmall bulb with a holder and socket and bridge a test probe connectedwire from the 12v pin supplied from the electrical connector, to one end of the bulbtwo wires on the bulb and socket.
[* black] FindNext find a ground supply nearby ( the best place would be the key hole) and put one end of thebridge another wire infrom it to it.
[* black] Put
the test probe tosecond available wire on the holder clampbulb and see whethersocket.
[* black] If
the bulb lights up while the ignition is offup, it means your clock has power.
[* icon_note] For testing, useblack] Take a 12vsmall bulb with a holder and socket and bridge a test probe connectedwire from the 12v pin supplied from the electrical connector, to one end of the bulbtwo wires on the bulb and socket.
[* black] FindNext find a ground supply nearby ( the best place would be the key hole) and put one end of thebridge another wire infrom it to it.
[* black] Put
the test probe tosecond available wire on the holder clampbulb and see whethersocket.
[* black] If
the bulb lights up while the ignition is offup, it means your clock has power.