Salta al contenuto principale

Modifiche al passo #4

Modifica in base a Vani-

Modifica approvata da Jeff Suovanen

Prima di
Dopo il
Invariato

Righe Passo

[* black] Now we're gonnaTo check the power supply of the clock ...clock, locate the holder which connects to the pin which we already supplied with 12v+ on the clock.
[* black] get ready withFor testing, use a 12v bulb with a holder,holder and a test probe connected to one end of the bulb, and that's our tester for now.bulb.
[* black] Find a -ve supply near byby ( the best place the key hole) and put one end of the wire in to it.
[* black] then putPut the test probe to the holder clamp which we mentioned earlier. and see whether the bulb lights up while the ignition is off
[* black] Now we're gonnaTo check the power supply of the clock ...clock, locate the holder which connects to the pin which we already supplied with 12v+ on the clock.
[* black] get ready withFor testing, use a 12v bulb with a holder,holder and a test probe connected to one end of the bulb, and that's our tester for now.bulb.
[* black] Find a -ve supply near byby ( the best place the key hole) and put one end of the wire in to it.
[* black] then putPut the test probe to the holder clamp which we mentioned earlier. and see whether the bulb lights up while the ignition is off