Salta al contenuto principale

Aggiusta la tua roba

Diritto alla Riparazione

Componenti & Strumenti

Modifiche al passo #22

Modifica in base a Andrew Optimus Goldheart-

Modifica approvata da Andrew Optimus Goldheart

Eliminato
Aggiunto
Invariato

Righe Passo

[* icon_note] In the next steps, you will use an iOpener to apply heat to the rear case of the iPad to soften adhesive holding the logic board in place.
[* icon_note] As you Reheat and place the iOpener in each of the indicated locations, leave it in place for at least a minute to soften the adhesive through the rear case.
[* red] The adhesive is in the form of six pieces of black foam tape—refer to this step as you work at heating and prying to keep track of where each piece is located.