Salta al contenuto principale

Aggiusta la tua roba

Diritto alla Riparazione

Componenti & Strumenti

Modifiche al passo #22

Modifica in base a Andrew Optimus Goldheart-

Modifica approvata da Andrew Optimus Goldheart

Eliminato
Aggiunto
Invariato

Righe Passo

[* icon_note] There are six piecesIn the next steps, you will use an iOpener to apply heat to the rear case of strongthe iPad to soften adhesive tape holding the logic board onto the rear casein place.
[* black] Make sure you pryred] The adhesive is in the logic board offform of each piecesix pieces of tape. Use these imagesblack foam tape—refer to this step as a guideyou work at heating and prying to check that all adhesive has been severedkeep track of where each piece is located.
[* icon_note] There are six piecesIn the next steps, you will use an iOpener to apply heat to the rear case of strongthe iPad to soften adhesive tape holding the logic board onto the rear casein place.
[* black] Make sure you pryred] The adhesive is in the logic board offform of each piecesix pieces of tape. Use these imagesblack foam tape—refer to this step as a guideyou work at heating and prying to check that all adhesive has been severedkeep track of where each piece is located.

Immagine 1

Vecchia Versione

Nuova Versione

Immagine 2

Vecchia Versione

Nuova Versione

Immagine 3

Vecchia Versione

Nuova Versione