Salta al contenuto principale

Aggiusta la tua roba

Diritto alla Riparazione

Componenti & Strumenti

Modifiche al passo #4

Modifica in base a Terrance-

Modifica approvata da Terrance

Prima di
Dopo il
Invariato

Righe Passo

[* icon_caution] Before bridge 2 batteries together, ensure voltage difference between them less than 50mV. New batteries will very likely have about 3.9V voltage, and varies very little.
[* green] Bridge one B+ to anotherB+ first. Use soldering iron and solder.
[* yellow] Then, P- to P-.
[* red] Leave Both B- open!
[* icon_caution] One more WARNING! Be very careful with B- test point. DO NOT MESS WITH THEM. B- are not protected by "Protection Circuits". Do NOT bridge B-, unless you know what you don't know!
[* icon_caution] Of course. NEVER short-circuit any B- to any B+, or P- to B+, or P- to B-!

Immagine 1

Nessuna immagine precedente.

Aggiunto

Immagine 2

Nessuna immagine precedente.

Aggiunto