Modifiche al passo #4

Modifica in base a Tyler Vincent-

Modifica approvata da Tyler Vincent

Eliminato
Aggiunto
Invariato

Righe Passo

[* black] Strip wire 1/4 inch fromred] Place the endpositive leg of the wire.
[* red] Use a soldering iron to attach
the new LED tothrough the circuit board.
[* black] Let the solder cool before placing
positive hole in the printed circuit board and remaining pieces backsolder it into the screwdriver caseplace.
[* black] Strip wire 1/4 inch fromred] Place the endpositive leg of the wire.
[* red] Use a soldering iron to attach
the new LED tothrough the circuit board.
[* black] Let the solder cool before placing
positive hole in the printed circuit board and remaining pieces backsolder it into the screwdriver caseplace.