Salta al contenuto principale

Modifiche al passo #4

Modifica in base a Andrew Krippner-

Modifica approvata da Andrew Krippner

Prima di
Dopo il
Invariato

Righe Passo

[* black] Ensure that the front panel is free by pulling back the black cover. If it does not pull back, remove any remaining nuts or screws
-[* black] Locate the three pin connecters between the two PCBS. Gently unplug them by pulling straight up. Use only one hand to ensure safety from electrical shock. This is a rare occurrence but only using one hand will protect you.
+[* icon_caution] Caution! While working in the amp head, use only one hand to ensure safety from electrical shock. This is a rare occurrence but only using one hand will protect you. Do not "ground" yourself by touching anything else with your other hand. Do not touch any unfamiliar components.
+[* black] Locate the three pin connecters between the two PCBS. Gently unplug them by pulling straight up.
[* black] Remove the PCB from the amp head and set it aside to get ready for soldering