Salta al contenuto principale

Modifiche al passo #9

Modifica in base a Nicolas Siemsen-

Modifica approvata da Nicolas Siemsen

Eliminato
Aggiunto
Invariato

Righe Passo

[* black] Using a wide pry tool, like this trim removal tool, go around the edge of the panel between it and the metal part of the door. You will find it held in place by plastic clips. Gently pry each clip out all the way around.
[* black] On an older car like the W123, there will likely be some broken clips. Some times, doors are being held in place by only two or three clips.
[* icon_caution] Be aware that even though there should be no screws holding the panel to the door at this point, you will want to carefully check that someone didn't use a screw in the past to make up for broken clips. If you try and pull it off without removing the screw, you could damage your panel.

Immagine 1

Nessuna immagine precedente.

Aggiunto