Salta al contenuto principale

Modifiche al passo #3

Modifica in base a bushing-

In attesa di approvazione

Prima di
Dopo il
Invariato

Righe Passo

-[* black] While pushing on the card slots and the headphone jack, use the plastic opening tool to carefully separate the back panel from the rest of the device
-[* icon_caution] Be careful of the wires that are on the inside of the device.
-[* icon_note] The right and left bumpers tend to fall out when the cover is removed. You can prevent this by turning the device over before removing the cover.
+[* black] Flip the unit over.
+[* black] Use a spudger to pry open the gap between the bottom case and the front panel. Work all the way around the case until the panel is free.
+[* icon_note] Avoid touching the L and R shoulder buttons, because they pop off easily and are difficult to reassemble. Keeping the bottom case against your workbench will help hold them in place.

Immagine 1

Vecchia Versione

Nuova Versione

Immagine 2

Vecchia Versione

Nuova Versione

Immagine 3

Eliminato