Salta al contenuto principale

Modifiche al passo #4

Modifica in base a Keith Yu-

Modifica approvata da Keith Yu

Eliminato
Aggiunto
Invariato

Righe Passo

[* black] Remove the T8 Torx screwdriver head and replace it with the 60 mm extension; then, add the T9 Torx head.
[* red] Loosen, but '''do not remove''' the two screws at the bottom of the 1.2-inch wide gap in the middle of the internal structure.
[* icon_remindericon_note] These screws are spring-loaded and will stay in the device, even when loosened; however, it is still possible for them to be fully removed. Be careful to '''only partially loosen''' them.
[* icon_remindericon_note] These screws are spring-loaded and will stay in the device, even when loosened; however, it is still possible for them to be fully removed. Be careful to '''only partially loosen''' them.