Salta al contenuto principale

Modifiche al passo #4

Modifica in base a Rachel Kangas-

Modifica approvata da Rachel Kangas

Eliminato
Aggiunto
Invariato

Righe Passo

[* red] Usingblack] Remove the T8 Torx screwdriver head and replace it with the 60 mm extension; then, add the T9 Torx head, loosenhead.
[* red] Loosen
, but '''do not remove''' the two screws at the bottom of the 1.2-inch gap in the middle of the internal structure.
[* icon_reminder] These screws are spring-loaded and canwill stay in the device, even when loosened; however, it is still possible for them to be fully removed. Be careful to '''only partially loosen''' them.
[* red] Usingblack] Remove the T8 Torx screwdriver head and replace it with the 60 mm extension; then, add the T9 Torx head, loosenhead.
[* red] Loosen
, but '''do not remove''' the two screws at the bottom of the 1.2-inch gap in the middle of the internal structure.
[* icon_reminder] These screws are spring-loaded and canwill stay in the device, even when loosened; however, it is still possible for them to be fully removed. Be careful to '''only partially loosen''' them.