Salta al contenuto principale

Modifiche al passo #4

Modifica in base a Keith Yu-

Modifica approvata da Keith Yu

Eliminato
Aggiunto
Invariato

Righe Passo

[* red] Using the T9 Torx head, removeloosen, but, '''do not remove''' the two screws at the bottom of the 1.2 inch gap going down the middle of the device.
[* icon_reminder] These screws are spring-loaded and can come out; be careful to not lose them. If you don't fully loosen the screw, then they can stay on the internal structure.
[* red] Using the T9 Torx head, removeloosen, but, '''do not remove''' the two screws at the bottom of the 1.2 inch gap going down the middle of the device.
[* icon_reminder] These screws are spring-loaded and can come out; be careful to not lose them. If you don't fully loosen the screw, then they can stay on the internal structure.