Salta al contenuto principale

Modifiche al passo #11

Modifica in base a kevin-

Modifica approvata da Nick

Eliminato
Aggiunto
Invariato

Righe Passo

[* black] Put the upper housing back on the drill. make sure that the upper housing lines up with the lower housing screw holes.
[* black] Put all eight screws back in the slots. P.S: don't worry, the screws are all the same size.
[* black] Put all eight screws back in the slots. P.S: don't worry, the screws are all the same size.
[* black] Tighten the screws back into place with the Phillips head screwdriver.
[* black] After the screws are back in place, make sure they are all snug.