Salta al contenuto principale

Aggiusta la tua roba

Diritto alla Riparazione

Store

Modifiche al passo #10

Modifica in base a Dave Fixedit-

In attesa di approvazione

Prima di
Dopo il
Invariato

Righe Passo

[* black] Slide the housing back over the magsafe connector. It goes on either way round (there is a hole for the led on both sides.
[* black] Squeeze in place with the pliers. If it doesn't fit over the circuit board fairly easily, check that you don't need to file down the solder joints some more.
[* black] Slide the first of the pieces of heatsink up against the plastic housing.
[* black] Keeping it tight, shrink it in place. This is important to help avoid a future failure.
[* black] Repeat with the outermost piece of heatshrink.
[* black] Try powering it up! Remember that it will take a few seconds before the LED illuminates.
[* black] Orange light - success!
[* black] Abrading the top of the casing and applying a big blob of hot-melt glue seemed to provide more permanent, if less elegant, strain relief!