Modifiche al passo #10
Modifica in base a Dave Fixedit-
- Prima di
- Dopo il
- Invariato
Righe Passo
[* black] Slide the housing back over the magsafe connector. It goes on either way round (there is a hole for the led on both sides. |
[* black] Squeeze in place with the pliers. If it doesn't fit over the circuit board fairly easily, check that you don't need to file down the solder joints some more. |
[* black] Slide the first of the pieces of heatsink up against the plastic housing. |
[* black] Keeping it tight, shrink it in place. This is important to help avoid a future failure. |
[* black] Repeat with the outermost piece of heatshrink. |
[* black] Try powering it up! Remember that it will take a few seconds before the LED illuminates. |
[* black] Orange light - success! |
Immagine 1
Nessuna immagine precedente.
Aggiunto