Salta al contenuto principale

Aggiusta la tua roba

Diritto alla Riparazione

Store

Modifiche al passo #7

Modifica in base a Dave Fixedit-

In attesa di approvazione

Prima di
Dopo il
Invariato

Righe Passo

[* black] Make sure that the cable comes off the centre of the circuit board so the housing will fit over it.
[* black] Also check that there is about 3mm of stripped cable on top of the circuit board as the strain relief has to fit here (see next photo)
[* black] Solder the other braid on the other side, in the opposite corner to the core. Try not to extend beyond the edge of the circuit board
[* black] Carefully file off any solder or cable that extends beyond the end of the circuit board.

Immagine 1

Nessuna immagine precedente.

Aggiunto