Modifiche al passo #6
Modifica in base a Cliff Harris-
- Prima di
- Dopo il
- Invariato
Righe Passo
[* black] Solder the core on to the opposite side to the |
[* black] Solder the core on to the opposite side to the |
[* black] Cut two pieces of the smallest heatshrink - roughly 4mm long. |
[* black] Slide on to the braid leaving roughly 3mm of braid free at the end where it joins the cable. |
[* black] Shrink in to place. If your heat gun is a bit powerful, use the soldering iron to supply the heat. |
[* black] Cut off the braids leaving about 3mm free beyond the heatshrink. |
[* black] Solder the first braid on to the chip side in the opposite corner to the chip. |