Modifiche al passo #6
|[* black] Solder the core on to the opposite side to the ship (in the opposite corner).|
|[* black] Cut two pieces of the smallest heatshrink - roughly 4mm long.|
|[* black] Slide on to the braid leaving roughly 3mm of braid free at the end where it joins the cable.|
|[* black] Shrink in to place. If your heat gun is a bit powerful, use the soldering iron to supply the heat.|
|[* black] Cut off the braids leaving about 3mm free beyond the heatshrink.|
|[* black] Solder the first braid on to the chip side in the opposite corner to the chip.|
Nessuna immagine precedente.