Modifiche al passo #3
Modifica di Robin Taylor —
Modifica approvata da Robin Taylor
- Prima di
- Dopo il
- Invariato
Righe Passo
| + | [title] Removing the Rotors... |
|---|---|
| + | [* black] Most Rotors I had dealt with a couple of taps and they could be pulled off. Not These! |
| + | [* black] The rotors seem to have a rust bond to the lugs and the wheel hub. I wasn't going to hit the rotors hard as it could damage the lugs and the wheel bearing. |
| + | [* black] I used a wire brush attachment on a cordless drill to remove as much rust as I could, a screwdriver to chisel off rust where the rotor met the wheel hub and heated the areas with a blow torch then sprayed them with PB Blaster. Then did the same to the other side. |
| + | [* black] When I could see a gap around the lugs I tapped the rotors loose with a mallet and pulled them off. |
Immagine 1
Nessuna immagine precedente.
Aggiunto
Immagine 2
Nessuna immagine precedente.
Aggiunto