Salta al contenuto principale

Aggiusta la tua roba

Diritto alla Riparazione

Store

Modifiche al passo #5

Modifica in base a Sam Goldheart-

Modifica approvata da Sam Goldheart

Prima di
Dopo il
Invariato

Righe Passo

[* icon_reminder] When reassembling your device, attach the gasket to the heat sink as shown.
[*
icon_note] These shots show howThe tail of the rubber fan gasket should be installed during reassembly. Be sure not to installfit into the gasket underneath the ear wherenotch in the heat sink, it should not end ofup underneath the heatsink is screwed down toheat sink tab that will rest on the upper caselogic board.
[* icon_note] Additionally, beBe sure the small post molded into the rubber gasket mates with the hole cut into the upper right corner of the logic board.
[* icon_reminder] When reassembling your device, attach the gasket to the heat sink as shown.
[*
icon_note] These shots show howThe tail of the rubber fan gasket should be installed during reassembly. Be sure not to installfit into the gasket underneath the ear wherenotch in the heat sink, it should not end ofup underneath the heatsink is screwed down toheat sink tab that will rest on the upper caselogic board.
[* icon_note] Additionally, beBe sure the small post molded into the rubber gasket mates with the hole cut into the upper right corner of the logic board.