Salta al contenuto principale

Aggiusta la tua roba

Diritto alla Riparazione

Componenti & Strumenti

Modifiche al passo #2

Modifica in base a Lawrence-

Modifica approvata da Geoff Wacker

Prima di
Dopo il
Invariato

Righe Passo

[* yellow] Remove the blue wire by gently pulling.
[* yellow] Disconnect the Brown cable. This is done by gently pulling the black tab away from the white plastic. This will loosen the tension on the brown cable allowing it to gently be slid away from the tab.
[* orange] Shown in the third picture, remove the 4 Phillips #1 screws connecting the circuit board to the optical drive assembly.
[* icon_note] The fourth screw is located behind the screwdriver in the third picture '''(highlighted in the orange circle)'''.