Salta al contenuto principale

Modifiche al passo #5

Modifica in base a Bryan Cervantes-

Modifica approvata da Bryan Cervantes

Eliminato
Aggiunto
Invariato

Righe Passo

[* red] Locate the two plastic clips holding the bottom and back cover together.
[* orange] Which clip you remove first is up to you. Rotate the device 90 degrees either left or right. Insert the flat end of a spudger horizontally between the back speaker and the back cover.
[* yellow] Place the flat end of the spudger behind one clip and pry it open. This may take repeated attempts.
[* icon_note] This is the hardest step because working at thisthe angle can beis awkward and the visibility is poor. HaveIf possible, have someone help you with lighting and holdinghold the device if possibleor provide lighting.
[* icon_note] This is the hardest step because working at thisthe angle can beis awkward and the visibility is poor. HaveIf possible, have someone help you with lighting and holdinghold the device if possibleor provide lighting.
[* icon_note] Once a clip has been removed, hold the bottom cover open so the clip will not fall back into place. One clip remains to be removed; you are almost there!