Salta al contenuto principale

Modifiche al passo #5

Modifica in base a Julien Blarel-

Modifica approvata da Julien Blarel

Eliminato
Aggiunto
Invariato

Righe Passo

[* red] This step can be tricky so get your bearings by locating the two clips holding the top and bottom cover together. They are at the center of the backside of the device.
[* orange] Insert the flat end of a spudger horizontally between the back speaker and the back cover as seen in the second picture. TheWhich clip you remove first is up to you.
[* orange] Insert the flat end of a spudger horizontally between the back speaker and the back cover as seen in the second picture. TheWhich clip you remove first is up to you.
[* yellow] Place the flat end of the spudger behind one clip and pry it open. This may take repeated attempts.
[* icon_note] Working at this angle can be awkward and the visibility is poor. Have someone help you with lighting and holding the device if possible. This is the hardest step so, should you get frustrated, try the other clip or take a short break.
[* icon_note] Once a clip has been removed, hold the bottom cover open so the clip will not fall back into place. One clip remains to be removed; you are almost there.