Salta al contenuto principale

Modifiche al passo #5

Modifica in base a Tarun Thiruma-

Modifica approvata da Tarun Thiruma

Prima di
Dopo il
Invariato

Righe Passo

[title] Remove the front-facing camera module
[* black] Use the flat end of a spudger to pry up bottom edge of the front-facing camera module.
[* icon_note] The camera module is heavily cemented in place with a rubbery adhesive. If it doesn't budge even after using alcohol, you may need to cut the adhesive with a craft or utility knife to help release the module, or you risk damaging it during removal.
- [* icon_caution] It is quite possible to pry up only the [https://d3nevzfk7ii3be.cloudfront.net/igi/gKT1yTGrSHkbb52x.full|internal sensor and hardware components|new_window=true] of the module without its plastic casing, which may damage the module. If you are replacing the module, this isn't an issue, and the following steps will describe how to remove the plastic casing separately.
+ [* icon_caution] It is possible to pry up only the [https://d3nevzfk7ii3be.cloudfront.net/igi/gKT1yTGrSHkbb52x.full|internal sensor and hardware components|new_window=true] of the module without its plastic casing, which may damage the module. If you are replacing the module, this isn't an issue, and the following steps will describe how to remove the plastic casing separately.
[* icon_note] If you must retain the camera module's functionality, you can try to reseat the sensor hardware back into its plastic casing before cutting and prying again, or proceed to the next step and reseat the sensor after removing the casing by itself.
-[* black] Remove the front facing-camera module.
+[* black] Remove the front-facing camera module.