Salta al contenuto principale

Aggiusta la tua roba

Diritto alla Riparazione

Componenti & Strumenti

Modifiche al passo #4

Modifica in base a Phryne-

Modifica approvata da Phryne

Prima di
Dopo il
Invariato

Righe Passo

[title] Bezel Removing
[* black] Set temperature of the Heat Platform at 100℃. Then putPut the OLED Screen Assembly on the preheated platform. Press the ‘Start’ button to suck the screen.
[* black] 1 minute later, remove the front camera and sensor holder. Cut out the top bracket with the Cutting Nipper. Then separateSeparate the bezel from the OLED with the Cutting Nipper.
[* icon_caution] Tips: when detaching the bezel at the bottom area of the phone, we need to insert the metal pry piece under the bracket covering the bottom flex cable bonding area and slide back and forth. This is to confirm that the cold adhesive here has been sliced open.
[* black] Set temperature of the Heat Platform at 100℃. Then putPut the OLED Screen Assembly on the preheated platform. Press the ‘Start’ button to suck the screen.
[* black] 1 minute later, remove the front camera and sensor holder. Cut out the top bracket with the Cutting Nipper. Then separateSeparate the bezel from the OLED with the Cutting Nipper.
[* icon_caution] Tips: when detaching the bezel at the bottom area of the phone, we need to insert the metal pry piece under the bracket covering the bottom flex cable bonding area and slide back and forth. This is to confirm that the cold adhesive here has been sliced open.