Salta al contenuto principale

Aggiusta la tua roba

Diritto alla Riparazione

Componenti & Strumenti

Modifiche al passo #3

Modifica in base a Phryne-

Modifica approvata da Phryne

Prima di
Dopo il
Invariato

Righe Passo

[title] Frozen LCD Screen Separator
[* black] Place the OLED screen assembly upside down into the -180℃ Frozen LCD Screen Separator. Insert
[* black] Insert
a 0.06mm metal pry piece under the bracket covering the bottom flex cable bonding area.
[* black] Slide
and slide back and forth to slice through the cold adhesive here.
[* black] Place the OLED screen assembly upside down into the -180℃ Frozen LCD Screen Separator. Insert
[* black] Insert
a 0.06mm metal pry piece under the bracket covering the bottom flex cable bonding area.
[* black] Slide
and slide back and forth to slice through the cold adhesive here.
[* black] Once done, connect the screen and test. All going well.
[* icon_caution] Tips: since the front panel sensor assembly flex cable is not connected, the default brightness of the screen is set at the lowest level.