Salta al contenuto principale

Aggiusta la tua roba

Diritto alla Riparazione

Componenti & Strumenti

Modifiche al passo #20

Modifica in base a Andrew Optimus Goldheart-

Modifica approvata da Andrew Optimus Goldheart

Eliminato
Aggiunto
Invariato

Righe Passo

[* black] Push a guitarSlide the lower left pick in betweento the front panel and rear case near the toplower left corner ofto cut the iPadadhesive on that corner.
[* black] SlideLeave the guitar pick towardat the front-facing camera to breakcorner. Do not pry any farther, and do not remove the layer of adhesivepick from the iPad.
[* icon_note] There are quite a few things to avoid
beneath the top display bezel.
[* icon_caution] Stop once you reach
lower bezel, so study the camera, as you might damage the camera or itsthird image closely:
[* red] Antennas
[* orange] Home button cavity
[* yellow] Digitizer
cable if
[* black] The following steps will direct
you slide the guitar pick over the camerawhere to pry to avoid damage to these components. Only apply heat and pry where directed.
[* black] Push a guitarSlide the lower left pick in betweento the front panel and rear case near the toplower left corner ofto cut the iPadadhesive on that corner.
[* black] SlideLeave the guitar pick towardat the front-facing camera to breakcorner. Do not pry any farther, and do not remove the layer of adhesivepick from the iPad.
[* icon_note] There are quite a few things to avoid
beneath the top display bezel.
[* icon_caution] Stop once you reach
lower bezel, so study the camera, as you might damage the camera or itsthird image closely:
[* red] Antennas
[* orange] Home button cavity
[* yellow] Digitizer
cable if
[* black] The following steps will direct
you slide the guitar pick over the camerawhere to pry to avoid damage to these components. Only apply heat and pry where directed.

Immagine 1

Vecchia Versione

Nuova Versione

Immagine 2

Vecchia Versione

Nuova Versione

Immagine 3

Nessuna immagine precedente.

Aggiunto