Salta al contenuto principale

Aggiusta la tua roba

Diritto alla Riparazione

Componenti & Strumenti

Modifiche al passo #3

Modifica in base a Andrew Optimus Goldheart-

Modifica approvata da Andrew Optimus Goldheart

Prima di
Dopo il
Invariato

Righe Passo

[* black] RemoveCarefully place a suction cup halfway up the iOpener from the iPad.
[*
heated side.
[*
black] Place a suctionBe sure the cup is completely flat on the bottom right of the front panel glass, just above the lower bezel and near the right edge of the devicescreen to get a tight seal.
[* black] WithWhile holding the iPad down with one hand on the devicehand, pull up on the suction cup enough to open a small gap betweenslightly separate the front panel glass andfrom from the rear panelcase.
[* icon_caution] Be careful to only lift the glass enough to insert an opening pick—any more and you may risk cracking the glass
.
[* black] RemoveCarefully place a suction cup halfway up the iOpener from the iPad.
[*
heated side.
[*
black] Place a suctionBe sure the cup is completely flat on the bottom right of the front panel glass, just above the lower bezel and near the right edge of the devicescreen to get a tight seal.
[* black] WithWhile holding the iPad down with one hand on the devicehand, pull up on the suction cup enough to open a small gap betweenslightly separate the front panel glass andfrom from the rear panelcase.
[* icon_caution] Be careful to only lift the glass enough to insert an opening pick—any more and you may risk cracking the glass
.

Immagine 1

Vecchia Versione

Nuova Versione

Immagine 2

Vecchia Versione

Nuova Versione

Immagine 3

Nessuna immagine precedente.

Aggiunto