Salta al contenuto principale

Modifiche al passo #6

Modifica in base a David Sylvester-

Modifica approvata da David Sylvester

Eliminato
Aggiunto
Invariato

Righe Passo

[* yellow] Remove the two 15 mm Phillips #0 screws holding the DLP heat sink to the light engine board.
[* icon_caution] Springs underneath the screws help hold the heat sink on top of the DLP chip. During reassembly do not tighten the screws down all the way. Doing so can damage the DLP chip.
[* yellow] Remove the two 15 mm Phillips #0 screws holding the DLP heat sink to the light engine board.
[* icon_caution] Springs underneath the screws help hold the heat sink on top of the DLP chip. During reassembly do not tighten the screws down all the way. Doing so can damage the DLP chip.