Salta al contenuto principale

Modifiche al passo #4

Modifica in base a David Sylvester-

Modifica approvata da David Sylvester

Eliminato
Aggiunto
Invariato

Righe Passo

[* red] Use pliers to remove the two securing bolts from above and below the data portport by rotating counterclockwise.
[* orange] Remove the seven 8mm phillips8 mm Phillips #0 screws holding the plate to the light engine board.
[* black] Gently hold each side of the metal frame and pull it straight back to reveal the board and heat sinks underneath.
[* red] Use pliers to remove the two securing bolts from above and below the data portport by rotating counterclockwise.
[* orange] Remove the seven 8mm phillips8 mm Phillips #0 screws holding the plate to the light engine board.
[* black] Gently hold each side of the metal frame and pull it straight back to reveal the board and heat sinks underneath.