Salta al contenuto principale

Modifiche al passo #2

Modifica in base a Alden Glassey-

Modifica approvata da Alden Glassey

Eliminato
Aggiunto
Invariato

Righe Passo

[* black] Use the screw driver with the 4.0 flathead bitmetal spudger to pry off the rubber bottom cover. It will be glued onto the bottom of the speaker.
[* black] Use the screw driver with the 4.0 flathead bitmetal spudger to pry off the rubber bottom cover. It will be glued onto the bottom of the speaker.
[* black] Work the rubber cover off by slowly going all the way around with the metal spudger, applying as much force as needed.
[* icon_note] Since the cover is glued, a heat gun at low temperature or a hair dryer may be useful to speed up the process. However it is not required in this step.