Modifiche al passo #7
Righe Passo
| [* black] If you want to replace the ball, remove the ball. | |
| [* red] To remove the ball, flip the circuit board over to the other side, and find the two prongs as indicated. | |
| [* black] Use a precision flathead screwdriver to dislodge the prongs from the circuit board and push the prongs through the slots. The trackball should fall out from underneath. | |
| - | [* black] Once inside the slots, do a soft pressing motion to make sure the prongs are all the way through. |
| [* icon_note] Check on the other side if the prongs are latched on. |