Salta al contenuto principale

Modifiche al passo #1

Modifica in base a Vanessa Esteban Diego-

Modifica approvata da Vanessa Esteban Diego

Prima di
Dopo il
Invariato

Righe Passo

-[* black] Looking at the less crowded half (the chin half) the speaker is under the black circular brace.
-[* red] Using the Phillips #1 driver remove the two 7mm screws holding it in place.
-[* black] Remove the black brace by lifting it away.
- [* icon_note] The speaker will likely fall out after lifting the black brace.
+[* red] On the bottom half of the device's head, locate the two screws on each side of the speaker. Using the Phillips #1 driver remove the two 7mm screws.
+[* black] Remove the black brace holding the speaker by gently pulling on it. The speaker will likely fall out after lifting the black brace.