|
Introduction |
| Replace the adhesive securing the front panel to the rear case of your iPad 2 CDMA. | | | Before you begin peeling and sticking tape, it's important to have clean adhesion surfaces on both the front panel and the rear case. Use a spudger to scrape off any large excess bits of original adhesive, then clean all of the gluing surfaces with a paper towel and rubbing alcohol or Goof Off. | | | Throughout this procedure, it is recommended to peel up each adhesive strip as needed. | | | Parts of this guide were shot with a Wi-Fi model and as such the internals may look slightly different from the LTE model. The procedure is the same for both models except where noted. |
|