Salta al contenuto principale
Aiuto

Sony Cyber-shot DSC-T1 CCD chip Replacement

Replace a defunct CCD (charge coupled device) chip from the camera.

  • Autore: Rosario
  • Stima il tempo: 10 - 15 minuti
  • Difficoltà: Moderato

Follow this guide for the process of replacing the CCD chip, which is responsible for converting light into digital images. For safety reasons, battery should be first removed.

Passo 1 CCD chip  ¶ 

Locate and remove the 3mm screws on the bottom and sides of the camera with a JIS size #0  screwdriver. Locate and remove the 3mm screws on the bottom and sides of the camera with a JIS size #0  screwdriver. Locate and remove the 3mm screws on the bottom and sides of the camera with a JIS size #0  screwdriver.

Passo 1 CCD chip  ¶ 

  • Locate and remove the 3mm screws on the bottom and sides of the camera with a JIS size #0 screwdriver.

Passo 2  ¶ 

Pull the two halves of the camera apart.

Passo 2  ¶ 

  • Pull the two halves of the camera apart.

  • Place the two halves down with the insides facing you.

Passo 3  ¶ 

Find the two clips holding the motherboard to the black lens box.

Passo 3  ¶ 

  • Find the two clips holding the motherboard to the black lens box.

  • Slide the plastic opening tool in between the ribbon and the black part of the clip, then flip it up. (If difficult, your fingernail can also be used)

Passo 4  ¶ 

After releasing the clips, pull out the black lens box.

Passo 4  ¶ 

  • After releasing the clips, pull out the black lens box.

  • If the black lens box does not come out, go back to the previous step and make sure you released the correct clips.

Passo 5  ¶ 

Locate and unscrew the two 3mm screws on the bottom of the black lens box with the JIS #0 screwdriver.

Passo 5  ¶ 

  • Locate and unscrew the two 3mm screws on the bottom of the black lens box with the JIS #0 screwdriver.

Passo 6  ¶ 

With the tweezers remove the black tape to detach the chip from the lens box.

Passo 6  ¶ 

  • With the tweezers remove the black tape to detach the chip from the lens box.

Passo 7  ¶ 

Grab the chip with your thumbs and carefully pull it off. The copper tab will be glued to the lens box. Be careful not to rip it.

Passo 7  ¶ 

  • Grab the chip with your thumbs and carefully pull it off.

  • The copper tab will be glued to the lens box. Be careful not to rip it.

  • The attached copper ribbons are part of the CCD chip.