Salta al contenuto principale
Aiuto

Samsung Glyde Antenna Replacement

Foto Azione

Foto Azione

Passa all'azione, eroe! Questa guida ha bisogno di immagini che meglio illustrano come eseguire azioni specifiche.

Pallini!

Pallini!

Un migliore coordinamento tra i markup e il colore/tipo dei pallini aiuterà a rendere più chiara questa guida!

Necessarie Immagini Migliori

Necessarie Immagini Migliori

Delle foto più belle renderanno migliore questa guida. Contribuisci scattando, modificando o caricando immagini nuove!

Installation procedure for the Samsung Glyde internal antenna.

  • Autore: Cameron Law
  • Stima il tempo: 30 minuti
  • Difficoltà: Moderato

This guide will provide a step by step procedure for installing the internal antenna.

Passo 1 Antenna  ¶ 

Using a Phillips #00 screwdriver, remove the six 4mm screws holding the back case together. Using a Phillips #00 screwdriver, remove the six 4mm screws holding the back case together.

Passo 1 Antenna  ¶ 

  • Using a Phillips #00 screwdriver, remove the six 4mm screws holding the back case together.

Passo 2  ¶ 

Use a plastic opening tool to pry the case off. To do this, find a gap on any side of the phone, top preferably, and slip the tip of the tool in the gap. Now use moderate strength and slowly maneuver the tool around the outside until the case becomes loose.

Passo 2  ¶ 

  • Use a plastic opening tool to pry the case off. To do this, find a gap on any side of the phone, top preferably, and slip the tip of the tool in the gap.

  • Now use moderate strength and slowly maneuver the tool around the outside until the case becomes loose.

  • Using your fingers, take the case off.

Passo 3  ¶ 

The antenna is located on the bottom of the phone. It is the small rectangular shaped object sticking out on one of the ends. Use a plastic opening tool to prop the antenna out. To do so, slip the tip of the tool on one of the edges of the antenna. Use moderate pressure to pry the antenna out.

Passo 3  ¶ 

  • The antenna is located on the bottom of the phone. It is the small rectangular shaped object sticking out on one of the ends.

  • Use a plastic opening tool to prop the antenna out. To do so, slip the tip of the tool on one of the edges of the antenna. Use moderate pressure to pry the antenna out.

Passo 4  ¶ 

Using a plastic opening tool, disconnect the connector leading from the antenna to the phone. Using a plastic opening tool, disconnect the connector leading from the antenna to the phone.

Passo 4  ¶ 

  • Using a plastic opening tool, disconnect the connector leading from the antenna to the phone.