Salta al contenuto principale
Aiuto

Removing Minolta X-370 Lens Holder

Guida In Evidenza

Guida In Evidenza

Questa guida è stata giudicata eccezionalmente ben fatta dallo staff iFixit.

The lens holder can sometimes break or you need to access the inside of the camera. This guide will help you through these steps.

  • Autore: Nick
  • Stima il tempo: 30 - 45 minuti
  • Difficoltà: Moderato

You will be removing some leather grips, which you will reuse, to access some screws. Be careful not to tear these grips.

Passo 1 Lens Holder  ¶ 

Remove four 4.45mm screws and remove the alignment ring. Remove the interior metal ring and the black plastic ring.  Pay attention to the spring's location. Pay attention to the alignment of the interior metal ring and the black plastic ring.

Passo 1 Lens Holder  ¶ 

  • Remove four 4.45mm screws and remove the alignment ring.

  • Remove the interior metal ring and the black plastic ring. Pay attention to the spring's location.

  • Pay attention to the alignment of the interior metal ring and the black plastic ring.

Passo 2  ¶ 

Remove the two black stoppers. Using the metal spudger, remove the two triangular hangers. Using the metal spudger, remove the two triangular hangers.

Passo 2  ¶ 

  • Remove the two black stoppers.

  • Using the metal spudger, remove the two triangular hangers.

Passo 3  ¶ 

Using the metal spudger, peel off the right leather cover. Be careful not to tear the cover because you will need to use it again.

Passo 3  ¶ 

  • Using the metal spudger, peel off the right leather cover.

  • Be careful not to tear the cover because you will need to use it again.

Passo 4  ¶ 

Use the metal spudger to remove both the grip cover and the left leather cover. Be careful not to tear the covers because you will need to use them again. Be careful not to tear the covers because you will need to use them again.

Passo 4  ¶ 

  • Use the metal spudger to remove both the grip cover and the left leather cover.

  • Be careful not to tear the covers because you will need to use them again.

Passo 5  ¶ 

Remove two 5.3mm screws. Remove two 5.3mm screws.

Passo 5  ¶ 

  • Remove two 5.3mm screws.

  • Remove two 5.3mm screws.

  • Remove one 2.35mm screws.

Passo 6  ¶ 

Remove the left and right plastic covers. Remove the left and right plastic covers.

Passo 6  ¶ 

  • Remove the left and right plastic covers.

Passo 7  ¶ 

Remove two 6.65mm screws. Remove two 2.93mm screws. Remove four 5.3mm screws.

Passo 7  ¶ 

  • Remove two 6.65mm screws.

  • Remove two 2.93mm screws.

  • Remove four 5.3mm screws.

  • Remove the black plastic lens holder.