Salta al contenuto principale
Aiuto

Removing Panasonic DVD-RV31 Player Motherboard

Pallini!

Pallini!

Un migliore coordinamento tra i markup e il colore/tipo dei pallini aiuterà a rendere più chiara questa guida!

Foto Azione

Foto Azione

Passa all'azione, eroe! Questa guida ha bisogno di immagini che meglio illustrano come eseguire azioni specifiche.

How to remove the motherboard from the main DVD board

  • Autore: Kevin
  • Stima il tempo: 1 - 5 minuti
  • Difficoltà: Moderato
Sezioni

Passo 1 Motherboard  ¶ 

Remove the blue ribbon wire from its connector. When doing this, be cautious to not damage the connector. Place forefinger under cable loop as shown, gripping with thumb.

Passo 1 Motherboard  ¶ 

  • Remove the blue ribbon wire from its connector. When doing this, be cautious to not damage the connector.

  • Place forefinger under cable loop as shown, gripping with thumb.

  • Pull straight up. It should disconnect with little force.

Passo 2  ¶ 

Using tweezers or pliers, squeeze the tabs of the plastic fasteners together. While doing this, gently lift up on the motherboard until the fasteners are released. Using tweezers or pliers, squeeze the tabs of the plastic fasteners together. While doing this, gently lift up on the motherboard until the fasteners are released.

Passo 2  ¶ 

  • Using tweezers or pliers, squeeze the tabs of the plastic fasteners together. While doing this, gently lift up on the motherboard until the fasteners are released.

Passo 3  ¶ 

Remove the two screws securing the motherboard using a philips screw driver.

Passo 3  ¶ 

  • Remove the two screws securing the motherboard using a philips screw driver.

Passo 4  ¶ 

Lift the board from the side closest to the front panel (top of photo).

Passo 4  ¶ 

  • Lift the board from the side closest to the front panel (top of photo).

  • Gently apply force until bottom connector releases from power board below.