Salta al contenuto principale
Aiuto

MacBook Pro 13" Unibody Early 2011 AirPort/Bluetooth Assembly Replacement

Solo Prerequisita

Solo Prerequisita

Per favore tieni conto che questa guida è solo un prerequisito per altre guide.

Internal Prerequisite.

Internal Prerequisite.

Passo 1 AirPort/Bluetooth Assembly  ¶ 

Use the flat end of a spudger to pry the AirPort/Bluetooth ribbon cable connector up from its socket on the logic board.

Passo 1 AirPort/Bluetooth Assembly  ¶ 

  • Use the flat end of a spudger to pry the AirPort/Bluetooth ribbon cable connector up from its socket on the logic board.

Passo 2  ¶ 

Carefully pull the camera cable out of its socket on the logic board.

Passo 2  ¶ 

  • Carefully pull the camera cable out of its socket on the logic board.

  • Pull the cable parallel to the face of the logic board. Pulling it upward may damage the logic board or the cable itself.

Passo 3  ¶ 

Carefully move the AirPort/Bluetooth ribbon cable out of the way as you peel the camera cable off the adhesive securing it to the subwoofer and the AirPort/Bluetooth bracket. De-route the camera cable out from under the retaining finger molded into the AirPort/Bluetooth bracket.

Passo 3  ¶ 

  • Carefully move the AirPort/Bluetooth ribbon cable out of the way as you peel the camera cable off the adhesive securing it to the subwoofer and the AirPort/Bluetooth bracket.

  • De-route the camera cable out from under the retaining finger molded into the AirPort/Bluetooth bracket.

Passo 4  ¶ 

Use the tip of a spudger to pry the antenna connector closest to the logic board up from its socket on the AirPort/Bluetooth board. De-route the antenna cable from under the finger molded into the AirPort/Bluetooth bracket.

Passo 4  ¶ 

  • Use the tip of a spudger to pry the antenna connector closest to the logic board up from its socket on the AirPort/Bluetooth board.

  • De-route the antenna cable from under the finger molded into the AirPort/Bluetooth bracket.

Passo 5  ¶ 

Using the method described in the last step, disconnect the remaining three antenna connectors. De-route their cables from the slots cut in the AirPort/Bluetooth bracket.

Passo 5  ¶ 

  • Using the method described in the last step, disconnect the remaining three antenna connectors.

  • De-route their cables from the slots cut in the AirPort/Bluetooth bracket.

Passo 6  ¶ 

Remove the following five screws:

Passo 6  ¶ 

  • Remove the following five screws:

  • Two 10.3 mm Phillips screws

  • Two 3.1 mm Phillips screws

  • One 5 mm Phillips screw

Passo 7  ¶ 

Pull the AirPort/Bluetooth assembly and the Subwoofer upward near the center of the side of the optical drive until they clear each other.

Passo 7  ¶ 

  • Pull the AirPort/Bluetooth assembly and the Subwoofer upward near the center of the side of the optical drive until they clear each other.

Passo 8  ¶ 

Remove the AirPort/Bluetooth assembly, minding the fragile antenna contact near the corner of the upper case.

Passo 8  ¶ 

  • Remove the AirPort/Bluetooth assembly, minding the fragile antenna contact near the corner of the upper case.