Salta al contenuto principale
Aiuto

Canon Optura 100MC Button Pad Replacement

Prerequisiti Non Soddisfatti

Prerequisiti Non Soddisfatti

Questa guida non ha una guida prerequisita appropriata. Aiuta a trovare il suo partner ideale trovandone o scrivendone una!

This guide instructs about how to remove and replace the Button Pad (Play/Pause, Next, Previous, volume control) in the Canon Optura 100MC.

Use this guide to replace the button pad.

Passo 1 Button Pad  ¶ 

Remove the #00 Philips 3mm screw as shown holding the small circuit board on the side panel.

Passo 1 Button Pad  ¶ 

  • Remove the #00 Philips 3mm screw as shown holding the small circuit board on the side panel.

  • Hold the side panel and camera together, the orange ribbon cables and their ports are very fragile.

Passo 2  ¶ 

Remove the circuit board you just unscrewed. It is the black rectangle that says "CAUTION" on it.

Passo 2  ¶ 

  • Remove the circuit board you just unscrewed. It is the black rectangle that says "CAUTION" on it.

Passo 3  ¶ 

Remove the #00 Philips 4mm screw shown.

Passo 3  ¶ 

  • Remove the #00 Philips 4mm screw shown.

Passo 4  ¶ 

Remove the 3 #00 Philips 4mm screws shown.

Passo 4  ¶ 

  • Remove the 3 #00 Philips 4mm screws shown.

Passo 5  ¶ 

Remove the metal piece partly covering the Button Pad

Passo 5  ¶ 

  • Remove the metal piece partly covering the Button Pad

Passo 6  ¶ 

Pull the button pad out of its chassis. Pull the button pad out of its chassis.

Passo 6  ¶ 

  • Pull the button pad out of its chassis.