MacBook Air 13" Late 2010 Logic Board Replacement
Per favore tieni conto che questa guida è solo un prerequisito per altre guide.
- Autore: Andrew Bookholt
- Difficoltà: Moderato
Incorpora questa guida
Scegli una dimensione e copia il codice qui sotto per incorporare questa guida come un piccolo widget sul tuo sito / forum.
Passo 1 — Logic Board ¶
Use the tip of a spudger or your fingernail to flip up the retaining flap on the trackpad ribbon cable ZIF socket.
Pull the trackpad ribbon cable straight out of its socket toward the front edge of the Air.
Passo 2 ¶
Use the flat end of a spudger to pry the right speaker cable connector up and out of its socket on the logic board.
Passo 3 ¶
Gently push the tip of a spudger under the black plastic flap stuck to the display data cable lock to make the lock pop upward and away from the socket.
While holding the lock away from the socket, use the tip of a spudger and your fingers to gently remove the display data cable from its socket by sliding it toward the corner of the Air.
Passo 4 ¶
Use the flat end of a spudger to pry both antenna cable connectors up and off their sockets on the AirPort/Bluetooth card.
Passo 5 ¶
Gently de-route the antenna cables from the slot cut into the logic board.
Passo 6 ¶
Remove the single 2.85 mm T5 Torx screw securing the SSD to the logic board.
Passo 7 ¶
Pull the drive straight out of its socket and remove it from the logic board.
Passo 8 ¶
Remove the six 6.3 mm T5 Torx screws securing the logic board to the upper case.
Passo 9 ¶
Remove the inner two 4.9 mm T8 Torx screws securing the antenna cable retainer and left clutch hinge to the upper case.
Passo 10 ¶
Push the antenna cable retainer away slightly and remove the 3 mm T5 Torx screw securing the end of the heat sink to the upper case.
Passo 11 ¶
Passo 12 ¶
Carefully remove the logic board assembly from the upper case, minding any cables that may get caught.