Salta al contenuto principale
Aiuto

Disassembling Sony Vaio VGN-FW 590 Audio USB Board

Guida con Contributo Membro

Guida con Contributo Membro

Uno straordinario membro della nostra comunità ha realizzato questa guida. Non è gestita dallo staff iFixit.

A brief look at the steps to remove the bottom laptop cover of a Sony Vaio VGN-FW to get to the motherboard and replace a faulty Audio/USB Board (M760) or to simply blow out the dust from the fan and heatsinks.

  • Autore: Artem Nikulkov
  • Stima il tempo: 15 - 40 minuti
  • Difficoltà: Facile

This a simple process requiring only a small Phillips screwdriver and a slim flathead.

Note: A few trays for the screws, a wristband and an anti-static surface mat are ideal for safe handling of sensitive electronics.

Passo 1 Audio USB Board  ¶ 

- Remove battery.

Passo 1 Audio USB Board  ¶ 

  • - Remove battery.

  • - Remove memory tray door (1 Screw).

  • - Remove hard drive door (1 Screw).

  • - Remove hard drive (3 Screws).

Passo 2  ¶ 

- Remove all screws from the bottom cover. There are three types of screws. Marked here with Red Circles, Red Squares and Orange Circles.

Passo 2  ¶ 

  • - Remove all screws from the bottom cover. There are three types of screws. Marked here with Red Circles, Red Squares and Orange Circles.

Passo 3  ¶ 

- Remove CD/DVD Drive by sliding it out.

Passo 3  ¶ 

  • - Remove CD/DVD Drive by sliding it out.

  • - Remove three more screws, which were hiding under the DVD drive.

Passo 4  ¶ 

- Carefully remove the cover, by unpopping it with a slim flathead, slide it out away from the RJ-45, HDMI and VGA ports.

Passo 4  ¶ 

  • - Carefully remove the cover, by unpopping it with a slim flathead, slide it out away from the RJ-45, HDMI and VGA ports.

Passo 5  ¶ 

- The audio/usb interface card is now within reach. Just remove the two screws and carefully slide out the flat connector to remove the card.

Passo 5  ¶ 

  • - The audio/usb interface card is now within reach. Just remove the two screws and carefully slide out the flat connector to remove the card.

Passo 6  ¶ 

- Fire up the air compressor and blow out dust from the fan and heatsinks.

Passo 6  ¶ 

  • - Fire up the air compressor and blow out dust from the fan and heatsinks.

Passo 7  ¶ 

- If you are replacing your RAM, simply unpop the four latches and slide out the memory sticks.

Passo 7  ¶ 

  • - If you are replacing your RAM, simply unpop the four latches and slide out the memory sticks.