Xbox 360 Lower Case Replacement
Lower Case replacement.
- Autore: Walter Galan
- Difficoltà: Difficile
Replace a scratched or worn-out lower case.
Incorpora questa guida
Scegli una dimensione e copia il codice qui sotto per incorporare questa guida come un piccolo widget sul tuo sito / forum.
Passo 1 — Lower Case ¶
Stand the console vertically with the top edge facing down.
Carefully peel the warranty sticker off the console.
Passo 2 ¶
Use the flat end of a spudger to release the following latches:
Above the front-facing USB ports.
Beneath the front-facing USB ports.
Above the Memory Unit slots.
Passo 3 ¶
Insert the flat end of a spudger and pry upwards to release the last remaining latch located above the eject button.
Passo 4 ¶
Slightly lift the front portion of the lower case to ensure that the latches in the front have been completely released.
Passo 5 ¶
Passo 6 ¶
Press the Xbox 360 opening tool down into the clips securing the lower case to the upper case near the I/O ports.
While pressing down on the tool, push the lower and upper cases apart to separate the retaining clips.
Passo 7 ¶
While pushing the upper and lower cases apart, use the tip of a spudger or the finger of an Xbox 360 opening tool to push the long clip highlighted in red toward the center of the 360.
The clip should release, leaving the clips near the power connector as the only thing holding the upper and lower cases together.
Passo 8 ¶
Press the Xbox 360 opening tool down into the two remaining clips near the power connector.
Push the upper and lower cases apart to fully release the retaining clips.
Passo 9 ¶
Grasp the back portion of the lower case and lift it upwards to separate it from the console.